350-080 Sample Question

Question: 18

Which three statements best describe multicast operation on Cisco Nexus switches in a data center? (Choose three.)

A. Cisco NX-OS Software does not support PIM dense mode.
B. The command ip multicast-routing must be enabled in Cisco NX-OS Software before any multicast configuration is possible on the switch.
C. PIM CLI configuration and verification commands are not available until you enable the PIM feature with the feature pim command.
D. Cisco NX-OS Software supports multicast routing per Layer 3 VRF instance.
E. The default PIM operational mode on the Cisco Nexus 7000 switch is SSM.

Answer: A,C,D

350-080 Sample Question

Question: 17

To use ERSPAN, which command must be configured in a service profile?

A. capability erspan
B. capability l3 control
C. capability monitor
D. capability session
E. capability span

Answer: B

350-080 Sample Question

Question: 16

In a configuration with redundant supervisors, how many IP addresses are required to configure full remote access via management 0?

A. two IP addresses, one for each supervisor
B. three IP addresses, one virtual IP and one physical IP for each supervisor
C. one IP address that is shared among supervisors
D. none management 0 will use the IP address from the first SVI that is created

Answer : C

350-080 Sample Question

Question: 15

What are the three prerequisites for enabling FCoE on a Cisco Nexus 7000? (Choose three.)

A. M Series module
B. F Series module
C. no-drop QoS policy
D. NPIV feature
E. FCoE module license
F. Fabric Extender configured

Answer: B,C,E

350-080 Sample Question

Question: 14

When creating a role in a Cisco Nexus 7000 Series Switch, rules are used to define the type of operations that a role will allow the user to perform. Which two of these parameters cannot be applied as a rule? (Choose two.)

A. port-profile
B. command
C. access-list
D. feature-group
E. OID

Answer: A,C

350-080 Sample Question

Question NO: 13

FabricPath brings the benefits of routing protocols to layer 2 network Ethernet environments. What are the advantages of using FabricPath technology? (Choose three.)

A. FabricPath provides MAC address scalability with conversational learning
B. Loop mitigation with TTL in the frame field
C. STPl independence
D. 10 Gbps bandwidth
E. Layer 2 extensions between data centers

Answer: A,B,C

350-080 Sample Question

Question NO: 12

350-080 Testinside

Overlay Transport Virtualization (OTV) overlay interface is a logical multi access and multicast-capable interface that must be explicitly defined by the user and where the entire OTV configuration is applied. Which statements are true about OTV overlay interface? (Choose two.)

A. When an OTV edge device receives a Layer 2 frame destined for a remote data center site, the frame is logically forwarded to the overlay interface.
B. The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the join interface toward the routed domain.
C. When the OTV edge device receives a Layer 2 frame destined for a remote data center site, the frame is logically forwarded to the join interface.
D. The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the overlay interface toward the routed domain.

Answer: A, B

350-080 Sample Question

Question NO: 11

Overlay Transport Virtualization (OTV) join interface is used to source the OTV encapsulated traffic and send it to the Layer 3 domain of the data center network. Which statements are true about OTV join interface? (Choose three.)

A. Join interface is a Layer 3 entity, and with the Cisco NX-OS release 6.0, it can only be defined as a physical interface, physical subinterface, Layer 3 port channel, or Layer 3 port channel subinterface.
B. A single join interface can be defined and associated with a given OTV overlay.
C. Multiple overlays can also share the same join interface.
D. Join interface can be a loopback interface.
E. The join interface is a Layer 3 entity that can be defined as a physical interface but not as a logical one.

Answer: A, B, C

350-080 Sample Question

Question NO: 10

What is the mechanism that is used to allocate MAC addresses that are assigned to the VDC for
the system MAC address?

A. NX-OS uses a random MAC address from the IEEE OUI block that is assigned to Cisco.
B. The VDC system MAC is pulled from the active supervisor and concatenated through a hash to
ensure uniqueness.
C. NX-OS uses a value that is based on a range that is assigned to the SPROM of the system
backplane.
D. The VDC system MAC is based on a range that is allocated to the first line card that is installed
in the switch.

Answer: C
Explanation:

350-080 Sample Question: 9

Question: 9

Which three capabilities make the Cisco Nexus 7010 switch an effective solution for the data center core? (Choose three.)

A. visualization
B. unified I/O
C. support for 48-port Gb/s line card
D. support for Data Center Service Modules
E. high performance
F. high availability


Correct Answer: B, E, F

What to study to get a big tech salary

Headquartered behind them, many students began their tertiary education soon. Here are the top levels of study to earn a high salary in space technology.

Basic Education Minister Angie Motshekga recently published the results matrix in 2015, revealing a 70.7% rate of success.
Many of these students will begin their studies soon, hoping to get a good grade leading to gainful employment.
All grades, however, are not equal. A person with an engineering degree, for example, is more likely to find jobs in high paying someone with a degree of any pass4sure cisco exam dumps.
This begs the question: What grades will get a job after high rating?
The following list provides an overview of the skills that are sought, and where professionals in the field of the house have more money.
The list focuses on the art and skills in these areas are listed. The salaries listed are for qualified and experienced professionals - not starting salaries.

Cisco Career Certifications – CCNA, CCNP, and CCIE

 Many telecommunications companies to declare Cisco professional certifications are valuable.

The most sought after skills include Cisco Certified Network Associate (CCNA), Cisco Certified Network Professional (CCNP) and Cisco Certified Internetwork Expert (CCIE).

Microsoft Certified Professional Developer (MCPD)

Many software development companies in South Africa said the Microsoft Certified Professional Developer certifications are in pass4sure Microsoft exam dumps demand.
The certification demonstrates solutions needed to build both web and rich user experiences and target customer skills.

The MCPD serves as the first Microsoft certification for developers of enterprise applications.

350-080 Sample Question: 8

Question: 8

Which statements are valid for a local SPAN configuration? (Choose two.)

A. Source and destination interface must be on the same host
B. Source and destination interfaces can be on different hosts
C. Destination vEthernet interface can be on a different VLAN than the source
D. Destination interface can be a physical port
E. Destination interface cannot be a physical port


Answer: A,D